Light Accessories and Wiring

Baja Designs DC Unwired Regulator/Rectifier

Converts rear turn signals into running lights, brake lights and turn signals

Converts rear turn signals into running lights, brake lights and turn signals

Needed to prevent rapid-flashing turn signal indicators and BCM trouble codes on 2011-Up HD CAN/Bus models when non-compliant turn signals are installed on the rear of the bike.

Intended to be used with non-compliant LED's that cause turn signal indicators to rapid flash. Get all of the features of the "original" Load Equalizer and keep your emergency flasher capability.

Designed to prevent rapid flashing turn signals. This unit is 100% solid state with thermal protection and produces virtually zero heat.

Converts rear turn signals into running lights, brake lights and turn signals

Hard-wired load equalizer is designed to prevent rapid flashing turn signals. This unit will produce heat but it does have thermal protection. Not intended for extended usage in 4-way flasher mode.

Provides a running light to the function to the front turn signal. This module also has a built-in Load Equalizer to prevent rapid flashing turn signals.

The Badlands Plug-N-Play Illuminator is a three-in-one system that turns stock or custom turn signals into running lights and brake lights with turn signal function. Increases visibility from the rear of the motorcycle. Runs with the smallest turn...

Allows riders to install (3) separate (red) LED turn signals (rear) on the left and right side that will sequentially flash when the turn signal button is pressed.

DYNAMIC: Once turn signal is pressed, the LED's running lights on that side will shut off, then begin to flash from off state to bright, turn signal state before starting the sequence over