Brake Hardware

Audi A6 2018-2012, A6 Quattro 2019-2012, A7 2017-2016, A7 Quattro 2018-2012, A8 Quattro 2018-2011, RS5 2011, RS5 2016-2013, RS7 2018-2014, S6 2018-2013, S7 2017-2013, S8 2017-2013, Porsche Macan 2020-2015This Part...

Yukon Gear & Axle manufactures a full line of top quality small parts to complete any job including ring gear bolts, crush sleeves, pinion nuts and washers, axle studs, thrust washers and much, much more. For all your differential small parts needs, look...

Yukon Gear & Axle manufactures a full line of top quality small parts to complete any job including ring gear bolts, crush sleeves, pinion nuts and washers, axle studs, thrust washers and much, much more. For all your differential small parts needs, look...

Wilwood’s Honda Civic / Acura Integra CPB Caliper Cable Kit contains all parts necessary for effective parking brake installation on these vehicles.

Wilwood’s Pad Shim Kits feature a steel and elastomeric construction that dampens vibration transmitted between the rotor and pad. This is an industry standard to reduce NVH (Noise, Vibration and Harshness) response in vehicle platforms. Shim kits...

Caliper wear plates are used to prevent pad “dig-in” and wear on aluminum bodies. Manufactured form stainless steel alloy for maximum abrasion resistance. This specific part number is used for Billet and Forged Dynalite 4 Piston and Dynalite / Dynapro...

Stop Light Pressure Switch, dual pole with a 1/8th pipe male inlet. Circuit turns on at 60-100 psi. Used in part #260-11179 Combination Proportioning Valve assembly. Plated steel construction.

This valve can be used as a brake shut-off. When energized, the valve will block pressure from reaching downstream. The valve does not prevent fluid from returning to the master cylinder. This eliminates the possibility of trapping pressure when...

Wilwood's two, four and ten pound residual pressure valves retain a minimum brake line pressure to help eliminate excessive pedal travel in both disc and drum brake systems. The two pound valve is used in disc brake applications where the master cylinder...

Wilwood’s Lug Mount Front Bracket kits mounts Lug mount calipers with 5.25” center to center mount used in various Wilwood calipers. Mounts are application (vehicle) specific and contain 3/8-24 clinch nuts for caliper mounting. Engineered from high...

Wilwood’s Balance Bar Bolts are manufactured from high strength alloy steel with a zinc plated anti-corrosion finish.

Wilwood’s Rotor Bolt kits contain bolts and hardware for mounting rotors specific hat or adapters.